This program card is used to set the programmable parameters of Hobbywing EZRUN and XERUN brushless ESCs. The front panel of the program card is printed for Seaking series R/C Boat ESC, but it can be used for EZRun, XERun and Platinum ESCs also.

1 Specification
1.1 Size: 88mm (L) * 58mm (W) * 14mm (H)
1.2 Weight: 40g.
1.3 Input Voltage: 4.8-6V (If the ESC hasn’t a built-in BEC, you must use an additional battery pack to supply the program card)

2 Programmable Items
A) The programmable items of LED_PC2A (Available for PLATINUM series aircraft/heli ESC)
#1 Brake Setting
#2 Battery Type
#3 Low Voltage Protection Mode (Cutoff Mode)
#4 Low Voltage Protection Threshold (Cutoff Threshold)
#5 Start Mode
#6 Timing
#7 Governor Mode
#8 Motor Type
#9 PWM Frequency
#10 Built-In BEC Output
#11 Motor Load
#12 Lipo Cells

Front Panel Picture of LED_PC2A:

B) The programmable items of LED_PC2B (Available for SEAKING series boat ESC)
#1 Running Mode
#2 Lipo Cells
#3 Low Voltage Cutoff Threshold
#4 Timing

Front Panel Picture of LED_PC2B:

C) The programmable items of LED_PC2C (Available for XERUN and EZRUN series car ESC of Version2)
#1 Running Mode
#2 Drag Brake Force
#3 Low Voltage Cut-Off Threshold
#4 Start Mode
#5 Maximum Brake Force
#6 Maximum Reverse Force
#7 Initial Brake Force
#8 Throttle Neutral Range
#9 Timing
#10 Over-Heat Protection
#11 Motor Rotation
#12 Lipo Cells
(Note: The item #11 and #12 are not available for XERUN series ESC of Version 2, they only available for EZRUN series ESC)

Front Panel Picture of LED_PC2C: